Spark Plugs
Losing power
firts ride on 650 xmr
firts ride on 650 xmr
FourTrax TransPlant
Bear Claw Tires
I have a 1985 Honda Fourtrax 250 and was thinking of getting new tires but sticking with the factory rims.
The factory tires on the rims are;
Front – 21 x 7 x 10
Rear – 25 x 12 x 9
Options for those sizes is very limited and I wanted to do something to bring up the front end a bit.
I was looking into getting some Bear Claw tires through Royal Distributing.
Front – 23 x 7 x 10
Rear – 25 x 12.5 x 9
Will height increase in the front cause any significant problems? (i.e. clearance & turrning)
Will the width of 12.5 fit on the factory rims that are 12 wide? (the bear claw tires are not available in 25x12x9)
If this isn’t a good option what would be a better option?
Thanks!
500 rebuild
I also had a hard time with mud in the rad and overheating which I wanted to try and address.
The only other problem I had was charging and battery life. We did a lot of winching everyday and the bike’s system simply can’t cope.
So, after 10 months thinking about it I finally stripped the bike and began the re-designed rebuild.
Along with the main frame, the front frame was also twisted so needed replaced. I decided to make the replacement myself which would also allow me to make other changes along the way.
So the list as I began stood at:
Rad relocate
Winch upgrade and relocate
Front storage mods
Auxiliary battery
LED lights throughout
General tidy up/repaint of parts
He goes nothing!
Scotch
roll cage question
ANY THOUGHT?
Modded renegade vs modded scrambler
14 renegade 1000xxc with air box mod, NPP dual dominators, dobeck gen 4, cv tech primary and STM secondary!
14 Scrambler 1000xp with air box mod, full big gun exhaust, dobeck gen 3.5, QSC clutch kit.
Sent from my iPhone using Tapatalk