Trailer access/parking at oregon dunes?

What area down by Florence/ Coos bay has the best access for long trailers. I have a dually with a 48′ living quarters trailer I’d like to take there and don’t want to go someplace I should not.

Also, coming from Washington what kind of off road permits will I need in Or? (RZR 1000) Thank you.

Trailer access/parking at oregon dunes?

What area down by Florence/ Coos bay has the best access for long trailers. I have a dually with a 48′ living quarters trailer I’d like to take there and don’t want to go someplace I should not.

Also, coming from Washington what kind of off road permits will I need in Or? (RZR 1000) Thank you.

Handle Bar Play

Just wondering if about 2" of play is normal in the 850’s. It doesnt seem like it should be. My girlfriend has a 500 and hers has no play in it, but mine has about 2" from center to either side before the tires start to move. My tie rod ends seem tight so i dont think thats the issue. Is there something i can tighten or is my steering box shot?

Tilt steering won’t stay?

My 2015 900 trail, the steering wheel won’t stay in a lower posi sitcom when using the tilt lever like on a car.

Is there some bolt I can tighten, or an easy fix for this ?

I really don’t want to haul the thing all the way from up north, to my house, then bring it in under warranty

Battery issue

I’m running two batteries. One factory and the other the 925L. I have an isolator run in between. Apparently I either wired wrong or one battery went bad. Last year seemed to do ok, but now my accessories are working fine which are ran off mainly second battery but my rzr won’t start after just a short while. Advice anyone ? Thanks.

Heads up on tie rod ends!!

Just got back from a ride this weekend, while on the ride I noticed that the steer wheel was off center so I stop to investigate. What I found out was that the jam nut on the tie rod end had come loose and the tie rod was starting to come out of the end. Lucky this was a slow ride otherwise this could of been ugly. I only have about 80 miles on it so the torque setting at the factory must of been off. Just trying to give you guys a heads up on this. Just double check them to make sure they are tight!!!

looking to snorkel my 550 xp

Hi guys,

Im new on this forum and I figured this be the best place to ask my questions. I have a 2010 Polaris 550 XP and I want to snorkel it but would like to do it my self. My questions are what size holes and pipe or flex hose will I need for air box? What’s size hole for the fenders? What size hose for the drive inlet and outlet? Any info would much appricated!

Chains designed for your personality!

Visit Us On FacebookVisit Us On TwitterVisit Us On YoutubeVisit Us On LinkedinCheck Our Feed