ok I have an 2015 Highlifter ordering the Highlifter 3-5 lift for it. Not going to big on tire but coming from and 800 with a 6 plus 6 rolling on 34" and the Highlifter is lower for sure. My question is how does it ride if you don’t turn the springs up and stay on low side of the lift with just the three? Love the ride of the new 1000 and don’t want to lose much of it. Thanks for your time.
2015 Snirt run
2008 Honda Rancher 420 ESP Problem
I have a 08 rancher that will not shift with the electric shift buttons. I can shift it with the emergency manual tool through all the gears fine. It has a brand new shift motor on it already. I pulled the shift motor off and when i hit the shift button it spins just fine. But when mounted back on the engine it does not shift the bike, but does make a noise when i hit the button. I have read that the most common problem is the shift angle sensor, could that be my problem even though the shift motor spins? I have attempted to interpret my diagnosit code which i believe is 22 but not sure. It has a long flash, then what seems like much shorter flash, then 2 very quick flashes. Thanks in advance for the help.
2008 Honda Rancher 420 ESP Problem
I have a 08 rancher that will not shift with the electric shift buttons. I can shift it with the emergency manual tool through all the gears fine. It has a brand new shift motor on it already. I pulled the shift motor off and when i hit the shift button it spins just fine. But when mounted back on the engine it does not shift the bike, but does make a noise when i hit the button. I have read that the most common problem is the shift angle sensor, could that be my problem even though the shift motor spins? I have attempted to interpret my diagnosit code which i believe is 22 but not sure. It has a long flash, then what seems like much shorter flash, then 2 very quick flashes. Thanks in advance for the help.
Duel battery with 4 terminal solenoid question.
Have a quick question. I installed the duel battery set up with a solenoid which has 4 terminals (2 large, 2 small). Everything works fine, but I am not near by buggy and on of my friends is also installing his and wanted to know what terminals goes where on the solenoid. I can not remember where the wires go for the two smaller terminals, I know one is ground and the other goes to the ignition just can not remember. Looking a the solenoid, the far left (large) terminal goes to the positive on the (newly added) fuse box, the far right (large terminal goes to the Positive on the battery, now I forget what the two smaller terminals go to. If we label them 1-4 (left to right), 1 (positive fuse box), 2 (?), 3 (?), 4 (positive on battery).. Thanks.
Tranny chatter?
My 2011 900 xp has 2200 miles on it and it does a aggressive chatter while driving along at very slow speeds. At 5 mph it’s perfectly fine. It seems like the rear end is slipping as it spins one tire then the other but only off the start. Under load no problem. Any advice or ideas would be greatly appreciated.
570 plow mount
does anyone know if the plow mount on my 2011 sportsman will fit a 570 Polaris the plow and mount is a Glaser from polaris
Tube notcher
What kind of tube notcher is everyone using for their cages
rzr plastics fuel pump ecu motor mounts gas peddle
rzr plastics fuel pump ecu motor mounts gas peddle best offers just need this stuff gone
front prop shaft
does anyone else sell these prop shafts? I have done the u joints twice and now the u joint is loose in the shaft. It is 550 here with the rear slip joint. crazy money.










