Hey Guys I’m new to the forum and it looks great. I just bought a 2015 rzr 900 S. Took it out and ran perfect for about 5 miles. When I stopped on a trail the engine started stuttering and engine light came on. I believe it went into limp mode but I was able to get it home. I see two error code 520277 and 520284. My dealership isn’t open until Tuesday so very frustrating. Has others had this problem and what exactly is it?
Thanks
so this weekend i noticed how low my RZR 4 sits from the rear, now between me (yes i’m fat), the wife and two kits, i have 650lbs of us, plus speakers, front and rear bumpers, roof, skid plate, coolers etc. and I don’t have enough ground clearance on the big ruts. I have not adjusted my stock shocks though, should i play around with the adjustments there or buy the Racertech spring/lift combo?
Please help I have installed a Super ATV 5" lift and highly confused of what tire will actually fit now. I have searched till the end of the Internet …. I have been tossing around Outlaws and Silverbacks. Currently I have some destroyed ITP 27" Attachment 134456
I took my 04 sportsman 600 twin out last week and when it got hot it quit and dumped gas out into the air intake. I rebuilt the carb today and found the needle and seat worn. When finished, it ran great. As soon as it got hot it started to act like it was fuel starved and quit. Won’t start at all now. Cooling down as I write. Anyone have any suggestions?
I was on a trail ride today. We stopped to have a sandwich and eat some watermelon. I got back in the razor and try to start it, the engine turned over but would not start.I had to get it towed back to the main road. Can someone please help me diagnose this problem.
Ok, well I have had this 4wheeler for about 3 months now and I love it. But I have a very serious problem that I absolutely cannot figure out, I took the carb off a few days ago to clean it and when I put it back on I started the four wheeler up and no gears would show on the selector. N, D, or R. So I looked around and noticed a broken wire on the sensor on the side of the carb. The greenish blue one to be exact. So I fixed the wire out it back together, and nothing. I tried to reset it, but it does nothing. So I kept messing with it, to the point where I disconnected just that wire from the plug and bam. Neutral shows up. And it runs fine, then the next day nothing again I pulled and put back the 30A engine fuse and it runs fine now in ESP but in auto it is like it’s staying in 1st gear. In fed up with it and I don’t want to drop 100s in sensors if it’s not the problem please reply…
Ok, well I have had this 4wheeler for about 3 months now and I love it. But I have a very serious problem that I absolutely cannot figure out, I took the carb off a few days ago to clean it and when I put it back on I started the four wheeler up and no gears would show on the selector. N, D, or R. So I looked around and noticed a broken wire on the sensor on the side of the carb. The greenish blue one to be exact. So I fixed the wire out it back together, and nothing. I tried to reset it, but it does nothing. So I kept messing with it, to the point where I disconnected just that wire from the plug and bam. Neutral shows up. And it runs fine, then the next day nothing again I pulled and put back the 30A engine fuse and it runs fine now in ESP but in auto it is like it’s staying in 1st gear. In fed up with it and I don’t want to drop 100s in sensors if it’s not the problem please reply…
Needing a front left brake caliper for my 2010 rzr 800 4 also looking into rotors but might just resurface them also need brake pads. Any suggestions for my rzr 4? Thanks
