Is there a slipe-on that runs under $200 new? Or, anyone got one in the garage used that they aren’t using?
These exhaust are just ridiculously priced. I put the full system on my truck including two mufflers and all piping for what a Yoshi slipe on will cost me.
Was just trying to get something with little deeper growl, but don’t care about increased performance, as it won’t likely be noticeable anyway
I recently went from an enclosed trailer to a small flatbed for pulling our ATVs. I regularly pull them long distances and was planning to order a couple of Can-Am covers for protection during transport. However, someone recently told me that an ATV cover will scratch the ATV significantly if used for this purposes (wind and associated friction I suppose). Does anyone in this forum have experience with this one way or the other? Your advice would be much appreciated.
In Europe the focus handlebar is canceled.
He wanted to know if someone has a Sportsman 1000 purchased in Europe and know that this cut point wiring to connect and operate
I have recently bought a 2015 Honda rancher 4X4 AT and am installing a 3000 lb. warn winch. My question is where do I safely splice into to put the power to the winch? I have herd there is a Black/White wire located just in the tiny access panel in front of the steering. I just don’t want to splice into the wrong wire. Thanks in advance for any help.
I came from the yamaha world. Having eveything from waverunners to dirt to street to sport.
But the renegade 1000 xxc has my full attention
So hello everyone
So my question to everyone what are people running I plan on doing
Snorkel
4 inch lift
Clutches
Either silverbacks or outlaw2s
Front rear bumper
Rear rack
Winch exhaust.
I purchased my first atv about a week ago and its a Sportsman 850. I have about 150 miles on it and there is a significant clunking noise when using the rear brake. There is also a loud clunking noise when going down a steep hill and applying hard pressure to the hand brake.
The noise is coming from the front right of the machine, I would guess right around the area of my right foot. Its a blatantly obvious clunking/rattling. Called the dealership, they "haven’t" had similar complaints and said they’d look at it, but I just wanted to check here first.
Any ideas? I’ve read a lot on the forum about clutch noise, etc., but I’m brand new to these machines and am not familiar with different noises.
Just found out there is a rally in Kinuso this Saturday. I’ll be there turning money into noise.
My inlaws were at this rally last year. They only had good things to say about it. When the people hosting it took in more money than they expected they doubled the prize money.
