I have a 2008 rzr 800 50" wide and have wheel spacers now but with the lifr my axels aren’t strong enough.
So I found 2013 rzr 800s a arms all around for sale am wondering if this switch around will work.
And if any any one else has done this.
Cause to buy new aftermaket is quite pricey
What’s your guys thought?
Hello all! I just purchased a used 1996 sportsman. I did an oil change yesterday with 10-40 valvoline Syn wet clutch and an STP filter. Now I’m reading and it looks like I should use 0w-40. Should I drain and refil. Also what about the filter is that okay to use?
Also I’m now ready about pinching of the oil line to prime, is this necessary?
Hello all! I just purchased a used 1996 sportsman. I did an oil change yesterday with 10-40 valvoline Syn wet clutch and an STP filter. Now I’m reading and it looks like I should use 0w-40. Should I drain and refil. Also what about the filter is that okay to use?
Also I’m now ready about pinching of the oil line to prime, is this necessary?
I am looking for some help with my RZR 900XP. I have made the following modifications, 975 big bore kit from team alba, 12.5:1 pistons, stage 2 cam from team alba, Carrillo rods, Dragon fire dual exhaust, Dobec Gen 4 controller.
Controller settings:
idle light cruise set to as rich as the controller allows, shows 16+ lean when at idle
Cruising 13.5
full throttle 12.5
Acceleration 11.5
It also has a clutch kit from team alba
Problem the exhaust glows red after a little driving, backfires out the exhaust at low speed
Does not return to idle after hard acceleration, wants to stay at 3500 rpm until the brakes are hit.
It would seem to be running very lean but the AFR gauge shows the setpoints put in when in closed loop, cruising and full throttle.
Any suggestions to help me figure this out would be appreciated.
Got a 2010 Rene 800 the front tires are rubbing on the tie rod ends so I need to move them out some. Need to be about 10mm or so just enough to clear. The reason why is because my gate is only wide enough that I rub now so 1" or bigger will not work. Anybody have any or now where to get them? All I’m seeing is 1" and bigger. Thanks!
Stock minus the lower radius bars from previous owner
High lifter 5" lift with max clearance radius bars rear, hitch, 1.5 forward arms, 14" sedona wheels on 32" mudder inlaws. 30" rigid lightbar, a few super atv bags and random other fun stuff.
Today, is my first day on the forum. I am very obsessed with making products for my needs on my RZR. I have turned it into a side business with our full service fabrication shop. Take a look at my photos and let me know what you think. The best products are being tested weekly at River Ranch Florida, I am looking for new ideas daily.
