My front pads are shot. My rotors measure about 3.3mm. Should replace them now, or wait till next time?
Also, what are the chances my rear pads are anywhere near gone? I didn’t have time to pull my rear calipers. And, I figure I use my fronts a lot more, and rears usually last a lot longer anyhow, right?
I have a new Gibson exhaust im installing. the most clearance in can get between the header pipe and valve cover is about 1/4" is this going to be an issue seems awful close for heat issues.
2009 RZR 800 S, 3381 miles, 365 hours, winch, front bumper, rock sliders, aluminum skid plate, 2" lift, gorilla axles (never has had oversized tires, just lifted for ground clearance) $8000 OBO, call after 5 pm, Sorry no trades and local pickup only, 812-798 six one one eight, located in Linton, Indiana
Spotted this Hawk Engineering Rzr at Crawling for a Cause in Jackson Missouri, and the wheels really caught my eye. Anyone have any information on how to do this?
I’m on my 3rd regulator and the voltage is still hovering at 12.0-12.6 and the regulator is getting smoking hot. Swapped to brand new battery and voltage is good with it . Could the stator be my problem? When cold and running in low around 10-15mph the output on the voltage will hover around 14.0 as it gets further down the road and warmer the voltage continues to drop. About 1-2 mile down the road I’m at 11.8-12.0 and 10mph in low. My other xp 1000 stays at a constant 14.3v and only varies maybe .1-.2 volts. I’m pretty much thinking it has to be a toasted stator but want to make sure if anyone else has had this problem. Thanks
Hi everyone, I just bought my first honda yesterday :)- 1988 fourtrax 300 4×4. It’s a little project, but not horrible. It runs good, shifts good, everything works mechanically. Cosmetically however, it’s a disaster. Almost all the plastics are busted, all the plastic is sun damaged, aftermarket gas tank that oem covers won’t fit over :r_c: I was just wondering, does anyone know any good sites to buy the fenders and such? Thanks, and I’ll try to post some pictures of it tomorrow
