Just wondering if anyone ran into issues with breaking axles while using heavy mud tires. I want to get a set of 27" mega mayhems but I’m worried about them being to aggressive grabbing a rock and snapping an axle. I ride up in mountains where the land is pretty Rocky and want a good mud tire
Need help with this clutch
Just recently bought an EPI mudder clutch for my 1000. After finishing the primary clutch there were two blue washers left on the compression tool. Not sure where they go. I don’t believe they are shims because if they were on the backside there would be nothing to space it. I’ve attached a pic. Any help as to where they go would be great.
A-arm mount bent?
Having a blast getting the rzr ready for memorial day weekend. Noticed some slop in my front upper a arm. It was sliding front to rear on the bolt some. Just replaced ball joints so wanted to fix this. Ordered the bushings and started looking after removing the arm. old bushings measure the same as the new ones. Decided to measure between the mounts and it is 1/16 to 1/8 of an inch wider on the left or loose side. Any advice on this? I have a bunch to do this weekend so any quick advice is welcome. Can provide pics if that will help.
Ompah (Ride for Dad) 2015
Ompah (Ride for Dad) 2015
May 2015 Honda ATV of the Month Contest – “Quad in Mud”
The May 2015 Honda ATV of the Month contest starts now.This month will focus on quads in mud! So post the best pic of your quad in the mud!
We welcome everyone including vendors to participate, however we will not pick the same winner within a 3 month period.
The contest will close in one week (Friday, May 22), and finalists will be chosen by staff and you guys will vote for the winner. Rules for entry are below:
- The photo must be attached to a post in this thread
- Only one picture will be allowed, so make it your best! (do not submit multiple photos or you will be disqualified)
- You must be the owner of the ATV.
The winner will receive a $25 Amazon gift card from HondaATVForums.net and be featured on the front page!
Looking forward to your entries!
New Member
New member from Sc, sayin hi.
Lock and ride storage bags
My son purchased a 09 sportsman 500 efi that has the lock and ride storage box with backrest but has not had the storage bags attached. He received the bags with it. Can anyone tell me how to attach these bags?
95 Xplorer 300 4×4 won’t start
So far I have replaced the old fouled plug (cylinder has compression and there is spark), changed all fuel lines, put a new needle in the carb and a bowl gasket, as well as check for spark. On first round of trying to start it, I had the top cap off the carb and after a few pulls it started right up so I shut it off and reassembled the carb. After getting everything set to the factory adjustments for a base line, the wheeler won’t start up but the engine will spin over as if it’s about to take off. I’m no expert when it comes to carbs so any pointers would help, I’m stumped on what to do next.
95 Xplorer 300 4×4 won’t start
So far I have replaced the old fouled plug (cylinder has compression and there is spark), changed all fuel lines, put a new needle in the carb and a bowl gasket, as well as check for spark. On first round of trying to start it, I had the top cap off the carb and after a few pulls it started right up so I shut it off and reassembled the carb. After getting everything set to the factory adjustments for a base line, the wheeler won’t start up but the engine will spin over as if it’s about to take off. I’m no expert when it comes to carbs so any pointers would help, I’m stumped on what to do next.
