Hello to all
I have a 1999 xplorer 400 and i can,t find any info. On how to get the rear wheel bearings out. They are like a unicorn compared to everything else i have seen ! Do no have the 2 jam nuts on outside like all the rest do ? Any help would be nice ! Thanks
Looking for feedback on utv giant apex seats for my 900xp before I spend several hundred dollars on them. I just added power steering and im looking to do a lot more riding with the addition of new suspension seats. Would appreciate your comments/suggestions on them or any other brand, and thanks in advance!
I am using a Ellipiss 7 with BCN. i was wondering if there are maps i can down load to it that have the trails with there trail # on it? i can download an area fine but there are no marked trails with how i am doing it now. any help would be great. I ride in Arizona
ok my parent atv’s stator went out and wasnt charging the battery i replaced it and put a good battery in it i went to start it last night and it will crank over fine like it wants to fire but then it will stop and not do anything until you let off the key and try and start it again i have also hooked up a booster box to it to see if that was the issue is this a common problem or is their a wire that is commonly rubbed raw i should be looking for any help is appreciated thanks
We have a set of Black and Red Twisted Stitch Vortex seats for a 1000 4 seater in stock and ready to ship. Will not separate goes as a set. $455 ea and the ride is free to lower 48 states. (shipping is expensive on seats)
They look just like the picture.
PM me if your interested or call 909-235-7980
Got my Ricks Voltage Regulator yesterday. Looks nice and installed very easy. I will note it is around 1 inch narrower on the bolt holes. You will have to drill 1 new hole. I moved mine up and out of the way so I had to drill 2 anyway.
My buddy’s got an 09 rancher 420 fm with 30" silverbacks and big gun exhaust that he bought used and its got a much snappier throttle response as compared to mine, meaning it takes very little throttle and it feels like the rearend wants to outrun the rest of the fourwheeler lol As far as we know, the pipe is the only performance mod it has (haven’t been in the engine to check for big bore and no fuel tuner either)
Mine is a 2013 420 fm with 28" silverbacks with a gear reduction but his had and still has a much snappier throttle as compared to mine before or after the gear reduction – heck even when I had smalled 26" or the stock tires as well.
He rarely has trouble turning those 30s in the mud as well, so what gives? Lol How come his seems so ready to run with barely touching the throttle? Does an exhaust really do that much power wise? At first I thought maybe a clutch kit was behind it but it actually seems quite the opposite when I think of how little throttle it takes to get his moving compared to mine where as I can heard and feel the slight delay/stall while rpms increase before the clutch grabs
Will fit:
Polaris RZR 170 : 2014+
This SuperATV Polaris RZR 170 half windshield comes complete with all hardware and instructions needed to make installation a breeze. Proudly manufactured in our facility in Madison, Indiana.
Key Features:
1/4” Makrolon® AR abrasion resistant polycarbonate construction
Hard coated on both sides provides extreme durability
Protection against chemical and UV attack
Can be used with soft or hard tops
Contoured to hood with full length rubber seal for a great fit
Easy to install – comes with all necessary hardware and instructions
Half windshield height is 9" at center
Keep the hot sun out while you’re on the trail with a Tinted Roof from SuperATV. Constructed of 1/4” heavy duty makrolon, this roof will provide protection from the sun, sticks and other debris while allowing light to pass through. Each roof comes equipped with all brackets and hardware for an easy installation.
1/4" Tinted Makrolon Material
Easy To Install
Keeps Out Debris, Sun and Rain
