Sorry if I haven’t found it yet or the topic has been previously discussed, but I think it would be cool to have a category for discussing riding gear, action cams, GPS, etc.

NewfieXmr and i went for a ride out at McLean, we had two fellas drop out half way through the ride. They Had obligations, suckers :th_smiliebanana2: lol

Colton wanted to go and find some mud, and mud we found…:yahoo:

I have a 07 TRX500FM rear differential that is making a weird noise and I cannot figure it out
It has been removed and split open and all bearings are good fluid is clean
I found a video on Youtube of someone who has the exact same issue
and its also a Foreman TRX 500 There is no play in the pinion gear and it does it with the shims in place, swithced or removed
Kinda going crazy on this one so any help is appeciated
Here is the video, this is exactly what mine is doing
https://www.youtube.com/watch?v=Zntb_6iIxtU

Got a chance to run the quad a little bit tonight. Just installed a CVTECH and STM. From a slow roll, when I pin it the RPMs jump to about 7050 and then drop and hold at 6850 through the pull ( until I run out of room). I don’t know yet how the primary is set up but will be calling 3P for info Monday. The helix in the secondary is a 40 EN and I believe there are 3 fiber washers installed. I believe this shift out is a little low. What is my target shift out rpm and any thoughts on how to get there would be appreciated. Also, I use the homemade 2 bolt method to remove the stock primary. Will this be OK to use on the CVtech? Thank for your input.

I need to replace both front and back tires, as I believe they are originals…..and are starting to wear smooth.

OEM Carlsile front 24x8x12 and back 24x11x12.

I drive all dirt roads and some rough terrain. No mud or rivers.

What changes can I make to sizing without buying new rims or adding spacers.

I was thinking about 25x8x12 front and 25x10x12 rear….as this may make steering a little easier and make the quad look better (higher).

What brands are recommended and is the sizing ok for the current rims?

Thanks

Hey guys I just got a 500af and the display is blank the neutral light is on. So I disconnected the connectors from the computer board in the display and it came back on other than esp was blinking. Here is the strange thing if I turn the key off and back on it goes blank again until I unplug it and plug it back in again. Any ideas?

My friend has a brand spanking new one of these and he let me take it for a rip today. I know it is a mission specific machine made to tackle big mud holes. My review……YUK. Just a big heavy awkward Tank. That is not me in the picture. I was happily on my Grizzly.

Attached Thumbnails

 

Went for a short ride and the front differential started spewing oil out of the left side around the axle. Unfortunately I believe the bearing is bad and not just the seal because I can wiggle the axle pretty good on that side and the other three axles have no play at all. I know I will have to pull the diff out but is there any pointers in rebuilding the diff? Also is there one kit that I should look into getting? I’ve seen one from quad boss and all balls so far but have heard horror stories about all balls so any opinions are appreciated. Not looking forward to this job at all but it has to be done and could use any pointers.

Thanks, Cody

How would I go about alighning the crankshaft and counter balance when I put the new ones in?

Hello . I have a 800R 2015 XMR and
I want to made some mod and change trotthle body , porting head and change cam .
I know it can give easily whit the boom fuel controller 25 to 30 HP but i want to know if one of you guys here made this mod ?
Thanks