Not sure if this is good or not but I’m in the process of wiring my light bar and their is a buzzing going on when the light is on and connected to the relay!
If I connect the light bar directly to the switch with no relay the buzzing noise from the light is greatly reduced but can still be heard if you are listening for it.
So will this buzzing cause anything? Any issue? Premature wear?
Also what is the buzzing? Resistance from the terminals or something greater?
I know their are a few electrical gurus out their that may lend their .02$

Hi, I have a 1988 trail boss 250. The Atv has power to the starter from the solenoid and has power from the key and the start button, which I’ve tested with a circuit tester. But when I press the start button nothing happens, not even a click at the solenoid.
I have recently changed the starter and solenoid hoping that they were the problem of it not starting.
I’ve put jump leads directly onto the starter and it cranks when I do that.
The cut off switch works as I’ve used it when the Atv was running from the recoil starter.
I’ve tried 2 different batteries which I know work, and that doesn’t make a difference.
Surely if everything has power to it, it must crank over?

I’m really stuck at what to do next.
If anyone has any advice that would be much appreciated.
Thanks

Anybody have experience with the Groundhog Max?

Doesn’t seem like there is a 2 inch receiver that will fit the 2015 model.

Any suggestions?

Thanks!

New to the forum!

Hope to learn a lot!

Hi, I’m looking for input on what I should ask for my 2013 Outlander 1000 XT.

It’s basically an XMR without the long chassis.

242mi
BRP Rad kit
PATV snorkel
29.5×10 OG Outlaws
2" spacer lift
ITP wheels
QSC Clutch kit

I’m the only owner. It’s never been beat on, or swamped, or rolled. Excellent condition.

Sent from my LG-H900 using Tapatalk

Recently purchased 1990 trx 350. My problem is I can find almost no reference to this model – as if it never existed. My suspicion is the model is actually a 1989 carried into 1990 year. I am using 1986 to 1989 trx 350 service manual which so far seems pretty close. Can anyone confirm which service manual and model number reference (need to order a starter motor: ha7-620 or ha7-773?) before I start down the wrong path ordering parts

Thanks

Anyone know the decibel level the Exo produces on a Renegade 800?

Long story short, I dislodged this wire while taking off the flywheel. Anyone know if I can re-soldier it to the stator? If so, is it supposed to be soldiered to the plate, or the coil of copper?

Thanks,

Attached Thumbnails

 

I have a 2008 Yamaha 450 grizzly and the rear brake stuck on and now it does not work. Any suggestions on how to take it apart to replace the brakes.
thanks
Ray

human verification – doesn’t work.
my password doesn’t work.

Sent from my SGH-T889 using Tapatalk