Torn between the QSC kit or cv tech whole primary unit. This quad will be primarily raced as a XC quad it is a sportsman which is basically the same mechanically but there is not a lot of race talk over there. There is only about 150.00 difference between the 2…I’m not a pro racer by any means so I don’t need the new drive and driven setup, just can’t decide between these 2 units.

What is the torque for the spindle nut on a Griz 700, 2009?
Thanks

Got bored tonight and decided to plasti dip the shroud on my grizz to see if I like the look. Beauty of plasti dip is if you don’t like it or if it starts to wear you just tear it off. Have already done some emblems on my truck and it worked out good and has lasted just fine so far. Here’s how she looks. What ya think should I leave it? I think I like it. So far I just did the left side.

Attached Thumbnails

 

 

 

Needing a stock muffler for my 03 grizzly 660. Previous owner thought it was a good idea to gut the stock one. Located at 47374

I have 4 Mudzillas that I pulled off of another ATV that I’m parting out. They are 24x12x12 in the back and 24x9x12 in the front. I know this tire is a little heavier than a stock tire. My question is; will it fit on my TRX 350 (87 model)? What size wheels will I need? and can the stock clutch handle that big a tire?

Thanks for the help in advance.

Slip on or full. I refuse to pay what they want for new.
Scrammy 1K

Slip on or full. I refuse to pay what they are asking new.
Let me know if anyone is selling.

Was on my bike for a ride tonight and noticed that when I flipped on my new heated grips my led light bar was flickering. The led bar is wired to my high beams and my heated grips are taped into the 12v outlet. Any ideas? As soon as I turn the grips off he light is normal

Thanks

I changed the oil in my 12 grizzly 700 today. Used a yamalube oil change kit. First, the recommended amount was 2.2 quarts which it seemed to take almost 3. Here’s where my question comes in. When checking the level do I sit the dip stick on top of the rubber grommet piece and pull it from there to check or do it push it all the way in to its secure position and pull and check. On the dipstick there is a raised rigid marking that I assume is full? Thanks in advance everyone.

Though I can’t understand anything they are saying….they look like they are having fun….

Looks like they know how to have fun!!!!