Got 980 miles on the quad. I was in some deep water, but the mud wasn’t all that bad. More like sandy silt, not that thick heavy stuff that weighs a ton. I was stuck in it up to the headlights only because the quad was up on the frame on a rut.

However, when I got home and was unloading it, I head the loud clicking and popping on the rear right axle… Lower CV joint is all messed up, boot ripped apart, etc… Turns, but grinds and sticks a bit, etc…

I figure I will just replace one, rather than try to repair it and get new boots and all that. It’s got almost 1000 miles on it…

What’s the cheapest, decent axle brand? I see gorilla and Rhino, but I am trying to keep the cost down because I also need new brake pads all around, and possibly a battery… While I was in the water, I got the "Lo 10.8" message on the dash… The battery was replaced by the dealer in August when the stator burned up from the wires rubbing against the frame and shorting out… They put in a new stator, new Regt/Rect and a new battery. I insulated the stator wires so I know it isn’t that, and I see a lot of people having issues with the crappy stock battery…

Anyway, how are the Sixity brand axles, and which one is the right one for the rear right side of this quad?

Or should I go Titan, or American CV?

I don’t do deep thick mudding… It’s more aggressive trail riding, shallow mud, and when it gets deep it is usually the thinner, sandier sand and silt sorta stuff…

Best value option?