I had it just quit running as I was driving it. I am not seeing any sign of power with the key switched on. Happened late in the day before we needed to leave the farm. Are the fuses the primary culprit? 2004 Honda Rancher ES 350 that went though some water 2 hours prior to the shut down.

Hi everyone, I decided to rebuild my 400ex (since engine had seized on me) I decided to do it myself to save money and also learn since I have always wanted to learn. It took me a while but I finally got the engine rebuilt and decided to mount and try to start it before I put more money into it (also to know if I did it right). This is where the problem start first I’m not getting any spark I removed all tape and plastic wrap from wiring harness to make sure all connections are good and no wire is cut or anything. That checked out good, also I jumped started it and it does start that’s way but that is where the second issue appeared I noticed the clutch wasn’t disengaging so I couldn’t keep the four wheeler running. My question is what would cause it not to disengage. I replaced clutch disc and springs when I rebuilt and I reopened the right side of the crank case to double and triple check that I put everything on right. Thanks in advance for any help

Hey there, I am new to the site. Just trying to save a little money. I need to replace the throttle cable. Do I have to remove the gas tank to do this?

Please help. Honda 420trx rancher won’t shift. Replaced shift motor and angle sensor. Will shift manually but hard to do. It will not even try and shift after replacement of parts. Any help would be appreciated.

Please help. Honda 420trx rancher won’t shift. Replaced shift motor and angle sensor. Will shift manually but hard to do. It will not even try and shift after replacement of parts. Any help would be appreciated.

good FF95 flywheel, 6 magnet
$55 shipped in the lower 48
nothing wrong with it, I just don’t need it.

Attached Thumbnails

 

The grease fitting on the rear drive shaft had the valve fall out. Can’t grease it and it’s getting water and dirt in it. I tried a couple times to get at the fitting to remove and install a new one. Does anyone have a special way of doing this without splitting the u joint?

The grease fitting on the rear drive shaft had the valve fall out. Can’t grease it and it’s getting water and dirt in it. I tried a couple times to get at the fitting to remove and install a new one. Does anyone have a special way of doing this without splitting the u joint?

I bought a 2002 Yamaha big bear 4×4. I’m from New Orleans LA. I look forward to reading everyone’s insight to keep this bike running forever. Thanks in advance.

I have a 07 Honda 420trx rancher. We have replaced the electronic shift motor and the angle sensor. It will not shift at all. It doesn’t even try. Does not click or make any noise at all. What other options do I have? Can manually shift but hard to do. After replacing the shift motor and angle sensor it stopped throwing codes but still will not shift… any ideas on what to replace next or work on next?