So i have seen some posts referencing using washers as spacers. So I got the new tires installed and they are wider than the factory Carlisle even though it is a 25x10x8. More squared off. There was only about an 1/8 inch between the tire and the rubber boot of the tie rod in so I put some grade 8 washers behind the wheel that are about 1/16 of an inch thick to give just a tad more space for now. Just want to verify the that the thickness is ok. I can’t imagine that using anything thinner would do any good. I think I will just end of ordering new rims. I may consider the tie rod flip, if I can find a good video on it to show how to determine where to adjust the TRE to. Pics of TRE are with washer installed. Tires are at 7 PSI, but will be going down to around 4 or 5 psi. Thanks for any info.
Cal