Is a grizzly 660 primary sheave the same as the 700

We just picked up today…what a beast! Drove it around the yard a few times…absolutely amazing ride…only thing I don’t like is the way it nose dives when you stop…will a stiffer spring help that or does it need a whole shock? Would like to level it out too…other than that this is amazing machine!

Attached Images

edited_1461887976636_1461891398692.jpg (51.5 KB)

I was looking at putting a small bar on my foreman 450 es. i was told that an upgraded stater would be needed. Can any one clarify if that’s true or if its not needed.

I just adjusted the valves and the bike has just over 1000km. The intake seemed good but the exhaust was tight so I adjusted to 74 mm feeler gauge. After it was done it took 5 pushes with the start to get it started, and after it started it had some ticking way more than it had before. Should I run it with the adjustment or I’m thinking I should recheck. And I did have it on TDC . Any thoughts?

Thanks

Does anyone have a diagram of where the oil injection line runs/connects to on a 1994 sportsman 400 4×4?

Sent from my iPhone using Tapatalk

So I sold an old 50 to a friend for 150 so I decided that’s my parts money. So now I can’t decide between a Polaris bumper or a front rack extension to hold my back pack. What have you found to be more useful. I know it’s a vague question but any tips would help

Sent from my iPhone using Tapatalk

I’ve been thinking of a cluch kit for my 500, I see a lot of people are using QSC kits, where is the best place to purchase one ?

I got side to side movement in both front tires and handle bars.. I am guessing tie rod ends?

Also have movement at from top to bottom so guessing wheel bearings? Right side is worse then left.

Also toe is bad, can notice it by just looking. Did some quick measurements and front of tires are 25-1/4 in apart and back of tires are 27-1/2 in apart.

What are good tie rods? Oem or aftermarket?

For wheel bearings I was going to go with oem or boss bearings.

I bought a Honda Foreman es 450 and it started having bad sputtering problems. I replaced the stator and coil cleaned the carburetor and am still having the same problem.