Hello! I’m in the process of changing the oil and filter, trans fluid and front and rear gear case lube. The question I have, is what Polaris products do I actually need? I’m not looking for a cross reference for a cheaper product, I’m looking for the actual Polaris product. I’ve read the manual, but it appears to be quite outdated as far as the products are concerned. I have deciphered that AGL is used for the trans and possibly Angle Drive for the front gear case? Is AGL also used for the rear gear case on this year and model or is it another product? I have spent hours and hours scouring through forums looking for the right answer and I’ve just ended up more confused than when I started! I would also be open to any advice on changing the fluids as the manual didn’t do the best job describing the location of everything. But the first order of business is just going to be getting the correct material for the job! Thanks for all of the help!

Just bought 16 outlaw 110 any suggestions or places to get performance parts?

Hey – I just picked up a Renegade with a Ron Woods exhaust and this thing is louder than a dump truck filled with dynamite driving through a fertilizer factory.

I regularly ride through national forrest and state areas where the rangers check sound levels. I ordered the Supertrapp end cap with the discs and I was wondering how many discs you guys are using to quiet the beast. I need to be at 96db or less.

Hey guys,

I’m trying to figure out how this bearing goes onto the grease holder in the swing arm.

I bought the All Balls bearing kit and one side is tapered and protrudes slightly passed the outer race. Take a look here:
Honda 300 TRX300 Rancher 350 Swingarm Bearing Kit New | eBay

I’m not sure which side should face up or down…

Thanks in advance for the help

Anyone been recently. Wondering about dust? Hoping for wet!

Repost…please delete

I currently run a vforcejohn Primary on my 2015 can am outlander 1000 xmr. Has anyone done anything to their Secondary to get more performance? I have asked about installing a Stm, but told it’s not worth the $ on the 1000 xmr.
I heard a stiffer secondary spring and/or shallower helix helps. Has anyone had good luck doing this?
Reason I ask is I participated in in a mudpit event and I did better than most, but 3 of the same Atvs had different clutching and they pulled through the deeper areas much better. I do have a PC5 installed too.

Sent from my SCH-I545 using Tapatalk

So i am thinking about going to an amusement park one day and ride at a park near by the next. I am not worried so much about traveling with it but am a little worried about leaving it in the bed of my truck while i am in the park all day.

What are some safety precautions you guys take when leaving your atv in the bed of your truck, if any??

2011 Wildcat Sterling edition 302 RL
32 foot 5th wheel is a rear living model and includes dual battery and propane tanks. Dual AC with 50 amp hook up. Black tank flush system. Two slides. Bedroom fireplace and residential queen size bed. 32 inch Toshiba flat screen. Tankless on demand hot water. Automated 6 point self leveling jacks. Corian counter tops. 20 foot electric awning. Two recliners, one sofa, and a dinning room table. Been very well taking care of and is in excellent condition. Asking 27K. OBO. Contact Lee 979-218-0939.

where is speedo switch on 2010 500 atv speedo doesnt work but everything else does any suggestion ty madfinn:)