Put my 1994 Polaris 400L in storage in 2007 as I didn’t really have a use for it at the time and all the starters had stopped working.
I decided to put a new electric starter on it ($7.00 more for the whole starter than the dealer wanted for just the brushes.) and get it running.
I was surprised once I got the new starter on and added a quart of gas in the tank it started right up. I was sure I would have to do carb work on it. The problem I had was the PTV was stuck and would not close up on the belt. Had to about take the whole rear fender set up off to get the PVT cover off, then needed a bolt 3/4" x 8" 16 threads per inch for the whole 8" of the bolt to pull the clutch off. Then 3 C clamps to get the shivs to move to the closed position so I could shine up the shaft.
Got it to moving smoothly and reinstalled it.
I used it to roll the lawn to start off, second thing I did was hook to the spring tooth harrow and loosen some ground I am going to dig up and use in some new raised garden beds this spring once I find the right spot with full all day sun also smooth out the ruts in the driveway. Got to make use of the 4 wheel drive doing that going up a steep hill.
Next I went out to the front yard and hooked on the deer blind and again used AWD to pull the deer blind into the pine trees out of the way of mowing this summer.

I’m happy to have it going again.

I had to buy a bolt 3/4" x 8" 16 TPI (make sure it its thread the full 8" to pull the clutch. Cost less than $5.00 a clutch pulling tool cost over $20.00 plus shipping.

After the clutch was fixed and a quickie bath to remove the storage dust.

hooked to the 2 section spring tooth drag.

Skidded the deer blind from the front yard to the pines so it isn’t in the way of lawn mowing.

A load of wood to replace the stuff I burnt last week I had figured would last till fall. Why do you Canadians insist on sharing your clippers expresses and vortexes when it is cold enough all ready.

Since the canoe is in the picture I have to share a mid February picture taken a day when the wind was howling and it was 30 below zero wind chill. that deer layed there for over 6 hours after I walked the dog in the morning.

[img width=640 height=480]http://i3.photobucket.com/albums/y60/twotracker/April%202015%20things_Feb%2024%202015_2701_zpsuw99 62z5.jpg[/img]

😀 Al

Put my 1994 Polaris 400L in storage in 2007 as I didn’t really have a use for it at the time and all the starters had stopped working.
I decided to put a new electric starter on it ($7.00 more for the whole starter than the dealer wanted for just the brushes.) and get it running.
I was surprised once I got the new starter on and added a quart of gas in the tank it started right up. I was sure I would have to do carb work on it. The problem I had was the PTV was stuck and would not close up on the belt. Had to about take the whole rear fender set up off to get the PVT cover off, then needed a bolt 3/4" x 8" 16 threads per inch for the whole 8" of the bolt to pull the clutch off. Then 3 C clamps to get the shivs to move to the closed position so I could shine up the shaft.
Got it to moving smoothly and reinstalled it.
I used it to roll the lawn to start off, second thing I did was hook to the spring tooth harrow and loosen some ground I am going to dig up and use in some new raised garden beds this spring once I find the right spot with full all day sun also smooth out the ruts in the driveway. Got to make use of the 4 wheel drive doing that going up a steep hill.
Next I went out to the front yard and hooked on the deer blind and again used AWD to pull the deer blind into the pine trees out of the way of mowing this summer.

I’m happy to have it going again.

I had to buy a bolt 3/4" x 8" 16 TPI (make sure it its thread the full 8" to pull the clutch. Cost less than $5.00 a clutch pulling tool cost over $20.00 plus shipping.

After the clutch was fixed and a quickie bath to remove the storage dust.

hooked to the 2 section spring tooth drag.

Skidded the deer blind from the front yard to the pines so it isn’t in the way of lawn mowing.

A load of wood to replace the stuff I burnt last week I had figured would last till fall. Why do you Canadians insist on sharing your clippers expresses and vortexes when it is cold enough all ready.

Since the canoe is in the picture I have to share a mid February picture taken a day when the wind was howling and it was 30 below zero wind chill. that deer layed there for over 6 hours after I walked the dog in the morning.

[img width=640 height=480]http://i3.photobucket.com/albums/y60/twotracker/April%202015%20things_Feb%2024%202015_2701_zpsuw99 62z5.jpg[/img]

😀 Al