Hi, I have a question about an older trx 250. The kick start shaft that comes out of the motor seems to have spun and will not allow a full kick. Can anyone speculate what might be causing this issue? Thank you in advance 🙂

Does anyone know whats the purpose of this connector at the end of the rear left light harness?

Purchased this 2016 Sportsman Touring 570 SP brand new from a Polaris Dealer. All electrical wiring stock.

See pics.

Attached Thumbnails

 

 

have a 1999 explorer 400, sputters and won’t run at w.o.t., good idle thru most of mid-range. replaced cdi box, same thing, replaced and adjusted carb, same thing. Seems to be carb, any adj. makes it worse. seems to be running to rich wide open. Any suggestions or similar problems?

My kodiak blows the battery side fuse as soon as I turn the ignition on in the starter relay pack. Any ideas.

Brian.

2014 grizzly se eps m 14" single row light bar and 2 4" lights with his headlights

Sent from my iPhone using Tapatalk

I’ve joined the forum because my father owns a 2000 Yamaha Kodiak and has lots of questions. He’s 67 and doesn’t like using the internets so he’s asked for my help. This seems like a good forum to be a part of 🙂

Recently, he’s had a problem with the front brake lever sticking when he squeezes it to stop. The brakes themselves work fine, but they won’t release on their own. If he pushes the bake lever forward to disengage the bakes, all goes back to normal.

I’ve used the search function but only come up with stuff where the brakes don’t stop the bike. Where do I start looking to diagnose this issue?

J

I’ve joined the forum because my father owns a 2000 Yamaha Kodiak and has lots of questions. He’s 67 and doesn’t like using the internets so he’s asked for my help. This seems like a good forum to be a part of 🙂

Thanks again for the help

J

Hi everyone have to rebuild the topend of my sons 400 (455) Sportsman MUD BOG RACER I’m going to bore it so what brand of piston is best suited for this engine it runs at 6500-7000 RPM is there one better for running at that RPM than another,if so which brand. Thanks in Advance.

Wondering If anyone has tried to mill the head on a 500 scrambler to get more comares sion? They don’t offer high compression pistons anymore so that was my next thought.

I have a almost brand new set of 4 – 28x11x12 mega mayhems I would like to put them on a 2016 outlander 1000xt. does anyone know if these tires will fit the stock rims and not rub anywhere? normally I would just try and put em on but I don’t have the machine yet. hope to pick it up Saturday.