That was 600 miles ago. I added extra insulation to my wires and it has been fine since then. The R/R was replaced at the same time, and I had a new batter installed, all under warranty…
Yesterday I was out on some really muddy trails at Durhamtown… When I would plow into a deep puddle, the quad would stall. I would get it started in a minute or two, and it would ride fine, but later in the day the "Lo 10.x) error would come on… sometimes it would stay on for awhile, other times it would go off. I pressure washed it last night and the code didn’t come back on… I will unplug and fish the stator wires out and inspect them, and repair if needed and then retape and really insulate it well… like over the top protection…
if the wires are intact and not shorting, what else would it be? The battery itself?
I have seen this happen, as has my buddy who has the same quad, when running through a stream where I know that the batter is getting submerged…
It really is a stupid place to put a battery…
Any thoughts?
If it is the battery getting wet and partially shorting out, maybe I should run large cables to the little trunk box and securely relocate the battery to there?
