So my neighbor just got a powder coating setup in his garage.. Going to throw some random parts in there for trial error runs.. If all goes well, anyone have any cool ideas on what to powder coat?
We have black, red, white, yellow and I think blue.. If you have any ideas and what color to do them throw them out or show a picture if you have any.. My bike is the base model yellow body.. I was thinking the stator cover, oil cover, and water pump cover in black.. The foot pegs in black and the handle bar clamps in black.. We’ll have to see if my front bumper fits and the rear grab bar.. The oven is small..
Getting some NPP pipes for my renegade 1k. Either the supernasty, lil nasty, or the turmoil. On a scale what are the loudnesses? And which one would you guys run from experience? And what are the differences between the 3?
Alright so I’ve done a lot of research on what I need to do or get.. But so many different posts say different things.. I just clarification from others..
If someone can specify everything that is needed for this mod, manifold adapters etc, I’d greatly appreciate it.. With my new goodies in building the motor, more air is going to be needed, but as I’ve said I’m ballin on a budget lol..
If anyone has the part numbers needed that’s even better! I don’t know if the manifold is only needed or if a whole other airbox and manifold is need or what..
My 2009 renegade starting ticking louder than it should on my last ride. After looking at the dipstick I found the oil was below where it should be. The motor has around 3000 miles on it and I dont baby it baby it when I ride it. Who do I get to rebuild my motor and what is it going to cost? Would I have any luck selling it as is?
I got a base model renegade 2013. Would anyone know off by hand if it has the small stator? Wondering if it’ll even have enough power to install powersteering. So just wondering what size the stator is on this unit
Thanks
I broke a front right axel and want to replace it but figured I might as well get a better grad axle so I can get a 2 inch lift. I was able to get a lift for my outty but it was a spring spacer and axles were never an issue. I was told it would be an issue for my Rene, now I herd that the g2 axles are much stronger than the g1’s, so I was wondering can I use those with a lift? Or should I just get a rhino or something. Any ideas?
I broke a front right axel and want to replace it but figured I might as well get a better grad axle so I can get a 2 inch lift. I was able to get a lift for my outty but it was a spring spacer and axles were never an issue. I was told it would be an issue for my Rene, now I herd that the g2 axles are much stronger than the g1’s, so I was wondering can I use those with a lift? Or should I just get a rhino or something. Any ideas?
