Does anyone have the part number for the 2017 xmr black hood there is 3 to pick from and not sure what one had the holes already cut into in

I just purchased a new throttle body assembly for my 2007 Sportsman 500 EFI and it already has the TPS attached to it from the factory. On the new throttle body assembly, do I need to do any adjustment to the throttle position sensor at all. I was told that the sensor is set at the factory and I should not loosen or adjust the sensor.

So is the install of the new throttle body assembly with the TPS attached just plug and play? Please advise.

These guys are out of French Canadia and make a really well reviewed trunk/seat. Just got in their classic version with tail light, and heated grips and seat. The electrical wires coming out of it are green, yellow, brown and white. Installation instructions indicate the white is ground, yellow is rear light, and green is ‘direct’ whatever that is. Literature doesn’t indicate anything about the brown wire, although it seems to be joined with the yellow wire while the other two wires are separate. Reminds me of the paired colored wires in a trailer light kit. Makes me wonder if the brown has something to do with the light as well, dunno.

So anybody have any idea where I start digging into the ’11 700 Grizz’s electrical system to start powering this bowhemeth up? Wes thoughtfully designed the harness with a connection in the middle so disconnecting is straight forward.

white is ground
yellow is rear light
green is ‘direct’
brown?

Installed cam chain , New rings, cylnder , head. After installation took for test drive and ran fine but had oil leak from right case . order gasket , put gasket on and try to,take for test drive and it won’t go . all wheels are locked up even in nutral. What did I do wrong when i,put right crankcase cover back on?

so I replaced my rear diff fluid and filled it to the hole which I found out is not a good thing this was before a big ride. I seen today that the left axel seal is leaking. is it just from over filling or do I have to replace the seals?

Thanks.

Has anyone had oil in the air box where the bottom and side of your air filter is filled with oil before? The top cover has a slight film of oil, I was playing quit hard last time it was out I’ll attach a few pictures, probably a 3/4"-1" or so of oil in the bottom. Just wondering if it’s from being over full, playing hard, or if my rings are pooped, it’s a gen 1 renegade. There’s is 3 pictures attached to give a general idea of what I’m talking about.

Attached Images

	IMAG0285.jpg (852.7 KB)
	IMAG0280.jpg (1.01 MB)
	IMAG0281.jpg (1,001.5 KB)

So my 98 600 acts like the belt is slipping but only when the engine as cold.when it warms up it pulls just fine but till then you have to mash on it to move. I’ve rode it without the belt box on and couldn’t see the belt slipping so I’m kinda lost.

Sent from my Iphone using Tapatalk

Thinking of trading for a 12 850. Not so sure I want to after reading about this issue. Any input is appreciated.

Thinking of trading for a 12 850. Not so sure I want to after reading about this issue. Any input is appreciated.

Thinking of trading for a 12 850. Not so sure I want to after reading about this issue. Any input is appreciated.