Howdy all, I have a 99 335. Runs pretty good, but has dim headlights and flicker slightly. Thought not having a battery might be a problem. Put the dead batt back in and put my meter on the posts and only 9 volts while idling. Only jumps 1/2 volt when revved. Not sure if that would be the stator or not. I am borrowing the exact same model from a friend and the stator wires test the same as the stator on the good one. Any ideas? Can’t afford to blow money on parts that aren’t bad and I don’t want to tear apart someone else’s ride to swap parts. Thanks!

Hello!

After upgrading my Grizzly 700 with stage 1 Elka suspension, riding trough summer trails (rough terrain over here!) was a breeze, maybe too much because after maybe 200 km i noticed a loose in my front right wheel (tie rod suepected)

Upon dismantling for replacement; i was horrified by this vision;

Anybody had this happen??

Hello!

After upgrading my Grizzly 700 with stage 1 Elka suspension, riding trough summer trails (rough terrain over here!) was a breeze, maybe too much because after maybe 200 km i noticed a loose in my front right wheel (tie rod suepected)

Upon dismantling for replacement; i was horrified by this vision;

Anybody had this happen??

Hello everbody ,Just got a 1999 trx300 fourtrax 2wd . No spark blown fuses rotted wiring solenoid battery cables etc no spark no oil light on when key on. So i ordered a wiring harness ,solenoid wiring assembly and a cdi box . I checked stator and pulser unplugged to see if they had output they did ,4to6 volts while cranking checked doide in box under handle bars not open or shorted . Applied harness and solenoid assembly and cdi . Didnt have new battery so hooked cables to my lawn mower and kick started the 4 wheeler oil lifht didnt come on when i turned key on bust it started neutral light very bright carb ran out of fuel. I app.ied fuel tank filled carb used starter button engine rolled over and smoke rolled out of new cdi and poped one of the fuses. Previous owner said it ran and the starter was bad had to kick start to run and ran fine till oil light flickered and died. Need help does any body ever has had this happen . Ccdi boxes are expensive . Does anybody think this is the voltage rectifiero

I am parting out a 2011 Can Am Max XT 500. It was totaled but still ran and drove afterwards. Let me know what you are looking for and I can let you know if I have it.

I was riding my bike earlier and I heard a clunking sound then the bike stopped moving. So I pushed it and it sound like something within the gears that’s tore up….what you guys think?

I was riding my bike earlier and I heard a clunking sound then the bike stopped moving. So I pushed it and it sound like something within the gears that’s tore up….what you guys think?

When going down a steep grade on my 400 it almost sounds like the gears are grinding. Get to level ground and it sounds normal. Anyone run into this problem.

What should my 07 outlander 800 be charging at. Measure at Bart 13.0ish volts

I went to clean my new uni air filter and found the housing had about an inch of what looks like clean motor oil in the bottom of the air filter housing???

Sent from my Samsung Note 4