got my new nrg quick disconnect steering wheel mount and a momo quirk steering wheel
when I went to install I took the retaining nut off and my steering wheel would not come off ,so I got my manuel and it says to remove the steering shaft assy. from the eps units so you don’t damage the eps says to install the nut 1/2 way and pound on it to loosen the steering wheel well after smacking it a few time with a 5 lb slege it still wouldn’t budge. and not wanting to mess up my steering shaft I finely had to cut my old wheel off
I cut a section of the rubber off to get access to the steel collar that goes onto the shaft then cut that to just above the shaft and took a cold chisel and split the collar then still had to use a brass punch to knock the shaft off the wheel what should have taken a couple minutes to remove ended up taking a couple hours but finally got everything done lucky I didn’t have a ride for the afternoon planned:sad:
when I went to install I took the retaining nut off and my steering wheel would not come off ,so I got my manuel and it says to remove the steering shaft assy. from the eps units so you don’t damage the eps says to install the nut 1/2 way and pound on it to loosen the steering wheel well after smacking it a few time with a 5 lb slege it still wouldn’t budge. and not wanting to mess up my steering shaft I finely had to cut my old wheel off
I cut a section of the rubber off to get access to the steel collar that goes onto the shaft then cut that to just above the shaft and took a cold chisel and split the collar then still had to use a brass punch to knock the shaft off the wheel what should have taken a couple minutes to remove ended up taking a couple hours but finally got everything done lucky I didn’t have a ride for the afternoon planned:sad: