Hey guys, I went to install my rox riser setup on my 14 Grizz and stripped the phillips number 2 screw heads that hold the throttle assembly to the bars. I could tell after the first one i tried that they were in there super tight. I took an impact screwdriver and hit it a few times. The screw head got mangled. I tried the second with a normal screw driver, same thing. These things are in there, and they are very soft. I want to install this Rox setup, but i need to get these screws out, and get new ones. Any ideas? I thought about trying to get a small vice grip on the screw head and turning it. I could weld a nut onto the screw head, but i’m worried i’ll melt the throttle assembly with the heat. My machine is basically new with 30 hours on it. Must have loctite on the screws.