I have the warn winch mount ,warn plow mount. This is kicking my butt try to mount this ! I did get it mounted with some difficulty. When i went to put the bumper back on i was able to bolt in the bottom bumper legs. When i went to attach the upper bumper legs they were an inch away of lining up to the frame attachment . So i was able to push up on the bumper and got close to the bolt holes,but not enough. Then i got a strap out and and a engine hoist and was able to lift enough to get the bolts into the upper frame ,geez! Next step bolting the winch mount to the front tabs on the bumper, can not get the carriage bolts in, misaligned by a goood 1/4 inch . I can file out the winch plate hole so i can get a bolt in . Anybody run into alignment problems ? Thinking the winch mount is not bent at the correct angle. Do i take it all apart and start from scratch , get a new winch mount hoping that would be better fit,or file out the holes and be done with it ? Im a little concerned about how much pressure it took to get bumper it self back on the bike , its on for now . Your input will appreciated . Thanks Don ps 2016 model