just got my reflashed ecu from evolution today…after i first installed it, i warmed it up cruising around for awhile. when i first started getting into the throttle it seemed snappy and more crisp. but from a dig, it felt to me as if it pulled harder 0-60 stock than with the reflash. stock it would run easily to the 71mph speed limiter, i tried on the exact road where i had ran 71mph previously and it pulled to 70mph and just never went any faster than 70 for probably close to half a mile…i can tell that the torque limter is gone because it does spin a little more and slide easier. then, i shut it off for 20min or so and hopped back in it, it ran noticably better than stock this round. but then at times when i would "hammer down" it seemed sluggish again, its like the power is inconsistent now for some reason almost?? ive been a part of tuning plenty of diesel trucks and i know the trans etc does a relearn process and such after a tune is flashed, but on a rzr im sure there isnt a "learning" process right? did i just get the only rzr out there that runs better stock than with a tune? lol. thanks!