I have a 1998 TRX300 2×4 and the starter went out. I got the starter installed without any problems but when I re-assemble the left side crank case something is causing it to bind up. I can hit the starter button before I finish tightening down the bolts and it turns fine but as soon as I get everything tight, the starter is not able to turn the gears. It actually binds up while the bolts still have threads showing. I have tried 5 or 6 times and I also checked the diagram and everything seems to be going together correctly. Everything spins easily when I turn them by hand before I install the cover. Any ideas or suggestions? The bearing seems to be spinning easily as I checked that last time out. It seems something is just a bit off causing it to bind up when tight.