Ok guys major problem here, I’ve watched every video read every thread tried every way, I’m installing a set of super mags
First time I got it done turned it by hand binding, looked rear exhaust valves fully open piston at tdc? Double check, all marks correct not even off 1 tooth
So retimed other way, turned freely, try to start, no go, firing plugs on exhaust stroke, so tear down again, retimed rear cylinder first, than turned counter clockwise until #1 in hole, timed front cylinder up, turned engine over by hand, now front exhaust valves hitting piston
HELP!!! Why what is this issue here
Yes correct cam is in correct spot, lash set properly, timing marks line up every time but still a big issue I need this done asap
First time I got it done turned it by hand binding, looked rear exhaust valves fully open piston at tdc? Double check, all marks correct not even off 1 tooth
So retimed other way, turned freely, try to start, no go, firing plugs on exhaust stroke, so tear down again, retimed rear cylinder first, than turned counter clockwise until #1 in hole, timed front cylinder up, turned engine over by hand, now front exhaust valves hitting piston
HELP!!! Why what is this issue here
Yes correct cam is in correct spot, lash set properly, timing marks line up every time but still a big issue I need this done asap