Tearing down my ’89 trx350D foreman front end

Well outlaws, after getting some time today, I had the chance to tear into my ’89 trx350D foreman front differential !. I replaced the front gear chunk, drive axles, and while I was there, tightened down my front swing arm. in the following pic’s, you will see how I start, and go through the process of unbolting the front knuckles to remove the front drive axles. you will also see how the front differential is built..sorta ?..lol. I also am including a pic of my homemade hub puller. I got tired of prying them off with screw drivers, and decided to make my own hub puller like we use at the main shop. all you need is an old Honda hub, and old c-clamp thread, as well as the part the c-clamp thread part screws down through, and walla..a homemade hub puller !. just put it on the 4-bolt studs of the hub, couple lug nuts, or you can use all 4 ?, then just turn the c-clamp thread down, and it pulls the stuck hubs off !.

Attached Thumbnails

Click image for larger version

Name:	DSCN1915.JPG
Views:	N/A
Size:	121.8 KB
ID:	46842
 

Click image for larger version

Name:	DSCN1916.JPG
Views:	N/A
Size:	121.4 KB
ID:	46850
 

Click image for larger version

Name:	DSCN1917.JPG
Views:	N/A
Size:	121.7 KB
ID:	46858
 

Click image for larger version

Name:	DSCN1918.JPG
Views:	N/A
Size:	120.7 KB
ID:	46866
 

Click image for larger version

Name:	DSCN1919.JPG
Views:	N/A
Size:	121.4 KB
ID:	46874