I have done tons of research on why my drain plug stripped. I went by hondas specs and it is now all the way stripped the threads… i have now read about the casting threads. I will be going to my buddies shop to use their tap kit to re-drill the hole to bigger size. I have also read where people broke the casting threads and the pan alone is 500$. Is there a way if i did break the threads to get the metals out of the pan? and to also add i have seen where people just drilled a big hole and used a boat drain plug instead of an actual drain bolt.
I wish it was simple to where i could get drop the pan and put a new one back off but i have seen where you have to pull the entire motor out…

ANY HELP OR SUGGESTIONS WOULD BE GREAT !!!!

THANKS FOR THE HELP FROM EVERYONE AND REMEMBER RIDE SAFE BUT HARD:yeahbaby01: