I know this may seem a bit unconventional, but I got out my trusty old GTECH today and did a few quick runs to see how it did. This is an older unit at 15+ yrs old. I used to run this in my trucks before I put in my Superflow chassis dyno. I always found it to be quite consistent and it proved itself once again:

Stock 0-60

4.80
4.76
4.91 (slight hook to wheelie on launch)

PC-V with my custom map 0-60

4.53
4.55
4.52

I see true promise for this device so long as I don’t cause too much attention running on an asphalt road. I’m hoping to run the fueling only map then timing only and see how they compare to the full tune. Later I have the QSC clutch kit, but I’m hoping to iron out as much in the tuning and test procedure as I can before installing. I may try to upgrade to a more advanced model if I can find one.