I went to replace an air filter on a ds90. One of the screws would not remove and would only spin. In order to make the situation easier on me I decided to remove the entire air filter box so I could work on it easier. The metal sleeve insert that the screw goes into was spinning. I tried everything to keep it from spinning but nothing worked. I eventually drilled it out and replaced the screw with a nut and bolt. When I went to install the air box back in place another metal sleeve starting spinning and now wont tighten down! Is this a problem on can-am’s cause I may not buy another one if I can’t do simple maintenance without problems. Is there a simple solution to keep these things from spinning?
Thanks for the help.