So here’s the deal:
– I bought 14" STI HD5s for my XP900 a while back, they have 30" Mongrels on them. I checked STI’s site and it appears as though they don’t have different 4x156mm offerings for different wheel stud sizes. I mic’ed them and the opening is ~12.75mm
First Q: these STI HD5s should be fine for my XP1000 or XP Turbo, correct?
– I have 1.5" UTV Inc wheel spacers: UTV INC 1½" POLARIS RANGER RZR RZR-S RZR-4 RZR-XP 900 WHEEL SPACERS – PAIR These have XP900 size wheel studs, but I ran them with the STI HD5s no issues.
Second Q: these should both correct for the different XP1000 offset (which was the point of them in the first place w/ the HD5s, in fact they gave me .5" more width per side than stock) and because they have a hub-centric ring there should be no issue there with the XP1000 wheels, correct?
– Finally, I had to run some aftermarket lugs due to the small lug-opening on the HD5s. They seem to have a smaller overall diameter (which, of course, was the point) and as such the taper seats very deep in the factory XP1000 wheels.
Third Q: I imagine factory XP900 lugs would be better suited to the combo of the XP1000 wheels on Factory UTV 1.5" XP900 spacers? Somemthing like this: https://www.rockymountainatvmc.com/p…ut+polaris+rzr Better yet is there an aftermarket lug nut for the XP900 9.525mm studs that have a larger overall diameter on the tapered section intended for running 1000 wheels on 900.
Sorry for all the Qs.
-TJ