I have read some on the reverse light mod but I made it in a different way. I also installed LED bar.
The function I wanted for reverse/rear worklights was:
-Reverse lights ON when in Reverse.
-Manually turning the reverse light ON with push button regardless of which gear is selected.
Solution was to fabricate a bracket and install a inductive sensor which is activated by some "soft metal mesh" (dont know the English word for it).
The metal mesh is mounted to gear selector linkage.
Then I just connected both Inductive sensor and +12v signal from rocker button on POD (yellow light in photo) to a relay.
Im not sure if sensor will fail when using rocker switch button (when using this +12v will be fed to sensors output, if so I will just replace it and add a diode to prevent current going "backwards".
Heated grip/thumb MOD
I have cheap set with 3-way switches without indication if OFF/LOW/HIGH is used. I wanted to have indication which mode is selected.
So I added two color diodes (each can light both green and red).
One for the grips and one for the thumb.
When Low heat is selected they are green and when High is selected they are red. As seen in photo upper is grips which is set to Low And Thumb is set to High.
Curved LED bar
I also installed a Curved LED bar.
I tapped the signal from High beams and ran it through a rocker switch so that I have the option to run ATV in high beam but without the LED bar.
Its the Blue rocker switch In Pod photo.
As usual I forgot to take photos during installation.
But here is some with end results.
Sorry for the dirty ATV, I will wash it this week…
18W Rear light and Factory mounted License plate light (standard on EU models?)
Inductive sensor mounted to heat shield
Pod with everything turned on
Curved LED bar, and LED DRL-lights