Primary clutch help

installed my primary last week after getting it back from dealer. torqued it to 96ft/lbs as per manual and everything was fine. Pulled the primary last night to adjust weights and when i reinstalled the primary and went to torque it down the stationary sheeve started turning clockwise while the rest of the clutch stayed in place.
I pulled the bolt out and popped primary off and marked the stationary sheeve and clutch shaft. I reinstalled to see if sheeve was moving on shaft but this time the bolt would spin and not tighten to torque specs got pretty tight but wouldn’t torque down. Pulled primary again and ran primary bolt in without clutch and i can get it to hand tighten the threads on the bolt look fine and i didn’t seem to be pulling threads out of crank, any suggestions?
I have new primary on back order due to small crack in spider i was running this until new one came in.