Last weekend I went for a ride and wound up stuck in a mud hole. I freewheeled my winch out, hooked up to a tree and tried to get out. The winch pulled me maybe 3 feet and died. No in or out. Called a few friends, got out and made it home. I finally got to troubleshooting it today and cannot figure out what ails it. I am hoping someone here can guide me. I breezed thru some posts here and tried banging on it, no go. I took the soleniod apart to check for anything burnt, nothing. I have continunity between the switch leads. I also have continunity between the blue and yellow winch leads. Reconnected everything and tested voltage.

This is what I have so far:
I have 12v at both the bar switch and remote, in and out, those seem fine.
At the solenoid I have:
Red/BLK-13v
Red/Blue-13v
Red/Yel-13v
Blue/Blk-0v
Yel/Blk-0v

When I push the switches, I get this for both in and out:
Red/Blk-0v
R-Yel-0v
R-Blue-0v
Blue/Blk-0v
Y/Blk-0v

Any insight? Im stuck.

Thanks for help in advance.

Oh, I should mention, it is a Warn RT30 winch and this was the very first time I have had to use it. Needless to say I am not impressed.

Thanks again