I wasn’t paying attention and put my one way bearing on backwards. All seemed okay till I put it in reverse and it jerked backwards and stalled out. I didn’t even hit the throttle. I pulled the primary clutch and realized I put the one way on backwards and when I pulled it off the bearing in the end fell out. I put the bearing back in by hand and flipped it the right way however now it sounds like a cricket when idling and under speed the cricket sound is constant (could also sound like a pin dropping). Also my clutch bolt had nearly all the threads rounded off; it was perfectly fine when I put it in the first time and I didn’t round any of the threads. Im thinking rebuild the one way bearing and I should be okay then. Any ideas/advice?

