Hey all. My 2012 Renegade 1000 has blown the middle accessories fuse under the seat twice now. Which gives me no power to the 4×4 actuator, and no headlights.. Possibly no fan but I haven’t rode it enough to get the fan to come on. Does anyone know if there is a COMMON problem with the wiring somewhere shorting to ground to pop the fuses? Before I start chasing wires throughout the whole bike I’m just wondering…
EDIT: As I posted this the thought of the fan shorting out could possibly be the reason for the fuse blowing.. Anyone have problems with a bad fan?
for those of u that have to take a med exam for pilots licence or truck licence
and have high blood pressure. this works for me. deep breathing fast for 30 seconds and my BP drops to 85 over 65. I did this while in the hospital in
Dec 2015 and the nurse was going to call the doctor when I told her to relax
I just cheated and she would not believe me. 2 min later it was back to normal.
she just shook her head and walked out.
Just picked up my new 2017 1000R XTP yesterday and my new Rigid Industries Dually D2’s came today. I am wondering if and where others have mounted them on their Outlanders. I searched and couldn’t find any photos. Appreciate any suggestions…..
also guys, i posted about a wire that comes out of the pod[comp.] , if cut, and grounded, it will let you into the comp., and get a new parameter to make the quad run better. any one know of this? it is supposed to be better than buying an after market controller. any help would be appreciated. thanks. [do not want to cut the wrong wire!!-lol!].
also guys, i posted about a wire that comes out of the pod[comp.] , if cut, and grounded, it will let you into the comp., and get a new parameter to make the quad run better. any one know of this? it is supposed to be better than buying an after market controller. any help would be appreciated. thanks. [do not want to cut the wrong wire!!-lol!].
hey guys, back!! great site, very helpfull!!!! any picks, or info. on changing out the one way bearing? need mine changed[very little engine braking at low rpm’s, and racheting noise] have the drive side off to install the 1.5 mm shim. on the drive clutch but have to order the one way bearing, and gasket. how much time is involved, and what exactly do i need to remove, and do to accomplish this? [ one way bearing], any help is appreciated. thanks.
hey guys, back!! great site, very helpfull!!!! any picks, or info. on changing out the one way bearing? need mine changed[very little engine braking at low rpm’s, and racheting noise] have the drive side off to install the 1.5 mm shim. on the drive clutch but have to order the one way bearing, and gasket. how much time is involved, and what exactly do i need to remove, and do to accomplish this? [ one way bearing], any help is appreciated. thanks.
The carb drain tube is pouring out gas coming out the drain on the bottom of the carb. The screw right beside the drain tube is not tight? Is it suppose to be would that have any effect on this its the screw with the Allen head any info would be awesome thanks In advance
