So I am new here and have a few questions. I have a 2013 RZR 800 LE Red. I bought it new. Long story short never let anybody play with your toys. Last Memorial day it took a hard hit on the right side. I spent the rest of the last year fixing it. I replaced the hole upper cage frame, "roll cage", bed box, front hood, right rear tire, right rocker pannel cover, and both front cage supports. When I went to put the new roll cage together the rear went on fine, but it was a B to get the front allinged with the front supports. I do think the frame is bent about a 1/4 inch. I did get everything back together, and it seems fine. Last weekend was it first time out since I got it all back together. She seemd to run good and everything held together, but I had a lot of squeaking frome the front. I think it just needs a good greasing up. My big concearn is I found that in a couple spots on the frame the paint on the welds was craking off. The big one is on the lower right front of the frame. I dont think the weld is craking just the paint. Would this be normal? Should I replace the Frame if its bent? I had a good dealer do a deatailed walk around after it was wrecked, and they didnt say anything about the frame being bent. Should it be very hard to alling the front part of the roll cage to the front roll cage support? Any help would be great. Thanks