Need help on what to look for

Yesterday while out riding, I went down an slope(3ft-4ft) that I have done many times before. This time I caught it at an angle versus going straight(driver error) and rolled the quad over in a stream(water up to my ankles) and had to bail off. I was fine and all just a hurt ego.

I picked the quad up off its side set it upright and looked it over. The front bumper on the gearshift side bent back into the corner plastics where the light is about an inch. Bent the handle bars as well and broke the end caps on the rear xt bumper. The engine stayed running the whole time.

Everything appears to be cosmetics except the gear shifter. I can put it all the gears fine but low. It’s like it’s not wanting to engage completely. What would I need to look at to before I tear the whole quad apart?

When I put it in low it would show on the dash and it would drive but then switch to high on the dash. I was able to ride in high the rest of the trip home and use 4 wheel drive etc no problems.

Attached Images
File Type: jpg image.jpg (981.4 KB)