hello folks,
I was riding for about 3 hours today and after taking another mile or so on the trail I decided to call it quits. It’s a darn good thing I stopped. I got my 2001 400ex back to the house and was washing the engine and noticed the pivot nut had fallen off and the bolt had worked itself about .75" out.
But I tapped the bolt back in and now I need a new nut.
The swing arm is RPM (was installed when I bought the quad) before I make a purchase I was wondering if this is the same nut as stock? The bolt side takes 17mm wrench…
The OEM nut says its 14mm, which might be the thread diameter?
OEM nut part#: 90305-GE8-003
I was riding for about 3 hours today and after taking another mile or so on the trail I decided to call it quits. It’s a darn good thing I stopped. I got my 2001 400ex back to the house and was washing the engine and noticed the pivot nut had fallen off and the bolt had worked itself about .75" out.
But I tapped the bolt back in and now I need a new nut.
The swing arm is RPM (was installed when I bought the quad) before I make a purchase I was wondering if this is the same nut as stock? The bolt side takes 17mm wrench…
The OEM nut says its 14mm, which might be the thread diameter?
OEM nut part#: 90305-GE8-003
Could I find a nut with the flat washer part attached at a hardware store and install that at the correct torque or is there something specific about this nut that must be OEM?
Thank you!!