There is no retaining clip on the oneway bearing (it’s gone, don’t know what happened to it). There was only one spring and part of one cup underneath the bearing (the other spring and cup are gone…I think you can see part of the spring stuck to the inside of the bearing sleeve). It appears as if the bearings are missing QUITE A FEW of the ball bearings (don’t know where those went).
This is the mess I found when I pulled the clutch and oneway. Does anyone have any idea what could have caused this to come apart like this? Better yet, any suggestions on what I need to do to keep it from happening again???
I’m assuming the broken pieces are what contributed to some unusual wear on the inside of my drive belt.
I don’t know if you can see these pics. They show up when I view my post but when I click on them, the screen is just black.?.?
Does anyone know a good/cheap source for the springs and cups, along with the retaining clip??? Part numbers would be great! My local dealer can’t seem to be able to find anything without a part number.
