My Rancher AT will not shift gears, the LCD display shows a solid bar, no flashing long or short bursts.
Once in gear, it will not shift back to neutral, if I roll the quad back and forth say 10 feet each way, it will shift back into neutral. Once in neutral it will start, if I put it in reverse the "R" will display, but when shifting into drive, the solid bar appears & will not shift.
I did replace the angle sensor and o-ring (but have a question).
The angle sensor has a rotating boss, what position should that be in to install it properly? Maybe that is the problem.
I have not had the quad in water, or sitting out in the rain, no crashes or rollovers.
Could it be the shift motor or did I install the angle sensor incorrectly?
My Rancher AT will not shift gears, the LCD display shows a solid bar, no flashing long or short bursts.
Once in gear, it will not shift back to neutral, if I roll the quad back and forth say 10 feet each way, it will shift back into neutral. Once in neutral it will start, if I put it in reverse the "R" will display, but when shifting into drive, the solid bar appears & will not shift.
I did replace the angle sensor and o-ring (but have a question).
The angle sensor has a rotating boss, what position should that be in to install it properly? Maybe that is the problem.
I have not had the quad in water, or sitting out in the rain, no crashes or rollovers.
Could it be the shift motor or did I install the angle sensor incorrectly?