honda 350 es part?

My honda 350 rancher es has been having intermittant shifting problems for the past 2 years after getting pretty deep in water. It will just flash for a few months and then shift fine…then the process starts over. Finally getting it taken apart to figure out what it is. If I follow the cable coming out of the let handle bar it goes to the front underneath just behind my winch.

There are 4 wiring connectors down there under the "hood". From the right side (if you were sitting in the seat) the 1st one is round, the second one is the one that I thought came from the left handle bar but alas…it comes from the actual display. I got it apart and the part coming from the led display area had corrosion in it pretty bad. I tried to scrape it off carefully but wound up breaking one of the pins off. So now I know it needs to be replaced. I have it taken off, the other end has 2 plugs that go into the computerized card in the display case…..what part is this? I need to get one ordered and can’t figure it out from the service manual.

Second question is could the corrosion on this part be what my problem was? And do I need to replace both ends. The other side (female end) looks pretty clean.

Thanks if anybody can tell me which part to order.

Keith

honda 350 es part?

My honda 350 rancher es has been having intermittant shifting problems for the past 2 years after getting pretty deep in water. It will just flash for a few months and then shift fine…then the process starts over. Finally getting it taken apart to figure out what it is. If I follow the cable coming out of the let handle bar it goes to the front underneath just behind my winch.

There are 4 wiring connectors down there under the "hood". From the right side (if you were sitting in the seat) the 1st one is round, the second one is the one that I thought came from the left handle bar but alas…it comes from the actual display. I got it apart and the part coming from the led display area had corrosion in it pretty bad. I tried to scrape it off carefully but wound up breaking one of the pins off. So now I know it needs to be replaced. I have it taken off, the other end has 2 plugs that go into the computerized card in the display case…..what part is this? I need to get one ordered and can’t figure it out from the service manual.

Second question is could the corrosion on this part be what my problem was? And do I need to replace both ends. The other side (female end) looks pretty clean.

Thanks if anybody can tell me which part to order.

Keith