I have Honda 300 Fourtrax 4×4 , put new bearings in the front knuckle about 1 1/2 years ago ,yesterday while installing some floor boards I seen a lot of play on one front wheel , so I went to Honda and picked up some bearings and seals and took it a part and changed them and the disc pads , the bearings were worn some but not that bad , pads were almost gone , put it back together and there is still some play in the hub ——— I was looking back at some threads , seems I remember some one talking about slack in 300 knuckles ????????? the bearing fits tight in the bore and had to be knocked in , and the hub’s collar and the cv axle look good , I do have a 2 inch lift and 26 Mudzillas which is hard on them ————— I was just thinking about it and wonder if the axle nut is pulling the hub far enough in before bottoming out