High oil pressure after oil change

I changed the oil in the RZR over the weekend, and noticed yesterday my oil pressure considerably higher than normal.

When it starts up (cold), the pressure climbs to about 50psi at idle, but jumps to around 70 at 5000rpm. After it warms up, it stays at about 40-46psi while riding, and about 20-26 at idle.

It used to cold start at about 40-50 psi, but would not go above 50psi even if I revved it. Warm idle was about 15 psi.

I used (and have been using) Rotella T6 5w40 oil. The only thing I used different was the oil filter. This time I used NAPA Gold 1356. I typically use WIX 51356. This is the first time using the NAPA Gold filters.

I checked my oil pressure relief. I could not get it out of the hole, but I do know it slides up and down in the hole. I could crank the engine, and watch a bolt that I put in the hole slide up and down. So I know it at least works somewhat.

Anybody using the NAPA gold filters noticed an increase in pressure ? I’m not sure if they have some type of pressure valve in them ?