Help With Horn Install

Could use some help…..

Today, I tried installing the Polaris horn kit (P/N 2872897), purchased from Yellowstone Polaris, last week. I really need some help! Yes, I do have the instructions, but, they don’t make sense. I’m having the following issues:

1. Where does the horn actually mount? This is for a 2013 550 EPS Sportsman. I can’t make heads or tails out of the instruction pics.
2. The second step, in the instructions is to remove the front center cable panel. What is that?
3. Step 4 mentions plugging the red/white wire into the piggy back connector on the wire harness. It goes on to say the red and white wires are located behind the ignition key. This doesn’t make sense. See attached pics. I’ve pulled the headlight cover, the cover below it, and the front lock/load cover. I cannot figure out where this red/white wire plugs in. Nor do I see a piggy back connector on the ATV’s wiring harness in the headlight pod.
4. Step 5 talks about attaching the brown ground wire around a bolt on a coil under the center cab panel. Again, where is this?
5. Step 6 is to secure the push button switch, to the handle bar, using clamps. As in a C clamp? Won’t this damage the switch?

Polaris Horn Kit above

Front of ATV – Does it mount somewhere here? No harness connection points that I can see?

Head Light Pod. No piggyback connector I can see…….

Another View of the Headlight Pod…..

If you’re thinking I’m clueless; you be right……….