I drained the front hub changed the fluid
also did an oil change ..
I drained the tranny fluid and according to the manual i downloaded it took 32 oz Well i couldnt get 32 in it i could only get 22oz and i stuck a Q-tip down in the hole and it showed about a half inch on it , 25 oz would be over flowing out the hole , i even drained it and re did it same results according to the instructions from the threads to the bottom where the oil should be is 1 5/8 from the top , I should have measured what i took out but figured what if it was low cant win LOL anyone who has some experience give me a shoot please just so i know im not gona burn the trans up ..
Also put a new pull cord assembly just in case .
I put in a new temp light , and im gona get the steel water pump propeller for safe measures ..
Put new inner tie rod and outer tie rod , probably gona do the others as well since they still have a little play the other ones where so bad i didnt notice the other one has a little play …
Moving forward im probably going to change the chain and sprockets , and try and get a good tire for when winter comes as this will be most of the time it will be ridden so if anyone has tire they like for the snow give me a buzz and i can check it out ,
Still have to take at look at the drive belt most likely change that also
The front rims are aluminum might grab a set for the back also since it has the steel ..
One thing at a time of course ..
Anyways thats whats been going on with mine dont know much about these first one i ever had so will be leaning on the pros for some advice im sure, Thanks for having me here !
Jim.
