I researched the wiring and based on what I found I decided to tap my light bar onto the high beam. Ok, nothing hard about that … I thought. More research … the wire I need to tap off is under the left fender. Found it with no issue, it has a quick connector on it so I disconnected it and pulled both ends up through the front accessory panel so I could get to them easily as in the following pic:
So far so good …
SO I turn the low beams on and pull out my multimeter and find 12VDC between the green and white wires, great this is going very well :
Still so far so good …
So I turn on the high beam and check the white/green and find 0VDC! YES it is going so easy …
One more check … the blue/white should show 12VDC not that the high beam is on … BUT NO! Nothing, notta … wth?
Ok so I put the multimeter up and reconnect the quick connector and the high beam is on …
Someone help me here, what in the world is going on? Why am I getting 0VDC on the blue/white with high beams on?